KB005: No data found in tool.

See also KB004: No data for depth xxx.

The symptoms described below pertain only to situations where Husky computers are used to operate the MI3 survey tool. This problem does not occur when using any version of the Palm software.

After the DOS HI program has programmed the tool for a multishot survey, you are presented with a screen requesting that you disconnect the cable at the tool. It is crucial that you follow these instructions immediately and to the letter.

Disconnect the cable AT THE TOOL before turning off the computer or exiting the program. Failure to do this will very likely reset the tool and cancel the survey.

You can ascertain that the tool is running properly before sending it into the hole by listening to it - if you hear a sequence of a low-pitched beep followed four seconds later by a high-pitched beep (this sequence of tones will occur once for each shot interval), then the tool is operating properly.

© Copyright 2000, 2001, Icefield Tools Corporation – All rights reserved. Permission to copy or print this document for personal non-commercial use is granted.